ISONEM ANTI-FIRE SOLUTION
ISONEM ANTI-FIRE SOLUTION, PROTECTING LIFE & ENVIRONMENT AGAINST FIRE With “Anti-Fire” it is possible to keep the “burning substance” out of the burning process and to block the start of any fire. Isonem Anti-Fire surrounds the molecules of the applied material and disables the contact with oxygen. The active substances contained in Isonem Anti-Fire create a very strong thermal isolation, and prevent the accumulation of heat which could start the burning process. A useful result of this thermal isolation property is that in case of a fire, a door which is treated with Isonem Anti-Fire, prevents the flow of high temperatures from one side to the other. Tests have proved: ISONEM ANTI-FIRE was applied to a clipboard door (14mm thick), one side of the door wasexposed to a continuous direct flame of 1500°C for 40 minutes whereas the reverse side has only reached the maximum temperature of 120°C.
- Boiling Point: 98°C
- Freezing Point: -3°C
- pH: 3,74 (acidic)
- TDS (Hardness) (1% water dilution) Sclerosis (Calsification Criteria): 739 ppm
- Evanescing (Evaporation) (60°C/ 24 hours): 50 %
- Deflagrate: None
- Burning: None
- Scent: None
- Frothiness (Buble): None
- Color: slightly blurred
RESULTS: As a result on the referred materials excluding darkenig no activities like burning, ignition, melting could be observed, and consequently it has been proved that this liquid can be used against fire activities very effectively. Besides, the fact that the Anti-Fire incombustibility liquid has the characteristics to be acidic and to have a very high pH value, shows that in case this liquid is applied to clothes, blankets and similar daily used products its anti-bacterial characteristics will be seen
WHERE TO USE “ISONEM ANTI-FIRE” AND HOW TO USE WOOD AND CHIPBOARD INDUSTRY:
1) Impregnation in pools filled with ISONEM ANTI-FIRE solution according to absorption characteristics of wood, or surface application by spray of ISONEM ANTI-FIRE.
2) On Mdf and Chipboards as per tested compatibility of initial dough with ISONEM ANTI-FIRE, used in the first production stage. If it is used by impregnation in pools the maximum application period for wood is one day. On chipboard and Mdf half an hour is enough. The absorption capacity of wood varies according to its hardness characteristic
PAINT INDUSTRY: ANTI-FIRE does not mix or combine with the dye substance. Since the aim is to prevent dye from burning, the correct application is like this: Before dye and polish but after grinding. ANTI-FIRE is applied to the prepared and grinded surface and completely dried. It is absolutely necessary that the surface is dried. Immediately thenafter dye (paint, color) and polish is spread.
GENERAL INDUSTRIES AND SECTORS: General industries and sectors: Styropor, Sponge, Cloth, Cotton, Wool and so forth, Application of ANTI-FIRE is made by wetting (impregnation, liquid bath) the material, squeezing out the not absorbed solution and then drying to finish.
PACKAGE: 5 lt plastic barrel.
CONSUMPTION: Depends on application and surface. ISONEM ANTI-FIRE solution should be considered as water and the necessary quantity for the applications to various materials should be calculated on the basis of the respective absorption quality and characteristics
STORAGE CONDITIONS/SHELF LIFE: 24 months from date of production if stored properly in unopened and undamaged original sealed containers at temperatures between +5°C to +35°C at dry conditions. Protect from excessive temperature and frost.