ISONEM FLOOR PAINT
I NEED MORE INFORMATION
1 + 4

ISONEM FLOOR PAINT

Tennis Court Paint

 

ISONEM FLOOR PAINT is a single component, water and acrylic-based coating material. USAGE AREAS: To obtain a dust free decorative surface on concrete and cement surfaces indoors and outdoors, ISONEM FLOOR PAINT is used in following locations: (without continuous contact with water): •Garages and parking lots with light traffic •Walkways amongst residences, pavements, locations of traffic signs etc. •Tennis courts, playgrounds and recreational grounds

PROPERTIES / ADVANTAGES: •Water based •Good abrasion resistance •Very good resistance against UV rays and does not cause colour fading. •High hiding power •High resistance and elasticity

TECHNICAL PROPERTIES: •Structure / Appearance: Liquid •Colour: Oxide red, dark gray, dark green, white (Upon request other colours can be produced.) •Chemical Content: Water-based acrylic resin •Density: ~ 1.50 ± 0,05 kg/I (at +20°C) •Application thickness: ~ 120 microns dft for 2 layers (primer+coating) •Pull off Resistance: 2,28 kg/cm² •Adhesion Resistance: >1.5 N/mm² •Elongation at break: 200 % •Drying duration: 24 hours (through dry)

Documents of the ProductDocuments of the Product
Usage AreasUsage Areas

MIXING: ISONEM FLOOR PAINT is ready to use and must be mixed thoroughly before use.
MIXING TIME: 2 minutes
MIXING TOOLS: ISONEM FLOOR PAINT must be mixed thoroughly with a low speed (300-400 rev/min) electric mixer or other suitable equipment.

Application TypeApplication Type
APPLICATION: All applications must be made in 2-3 layers. of the surface or in coloured surfaces, the third layer may be required.
APPLICATION DETAILS: •Consumption ~ 0.4 - 0.5 kg/m² / for each layer •The consumption is depended on conditions such as surface permeability, shape, roughness and material losses. •Preparation of Surface: Concrete surfaces must be cleansed from cement grout by using abrasive equipments and an open porous surface must be obtained. The weak concrete must be removed. The surface repairs, the filling of gaps and the surface adjustments must be made by using ISONEM M 03 Repair mortar. •All the dust, unstable materials must be removed from the surface preferably by brush and/ or a vacuum cleaner prior to application of the product. Application surface should be primed by ISONEM UNIVERSAL PRIMER adherance promoter.
APPLICATION METHOD / TOOLS: The applicaton can be done with a short or medium size pile brush. The airless sprayer equipment can be applied. The suitability of spraying equipment must be determined by an experiment. The second layer application is always recommended for the best view. It is recommended to wait 4 hours between layers. During the application and curing, the ambient and the surface temperature must be above +10°C.
Consumption and Suggestions

CLEANING OF THE EQUIPMENTS: Clean all the tools and equipment promptly with water after use.
CLEANING / MAINTENANCE METHODS: To preserve the view after the application, the materials remained on ISONEM FLOOR PAINT must be cleaned immediately with a broom or a vacuum cleaner. In pursuit of the application, do not use wet cleaning methods for 2 weeks. Do not use abrasive cleaning systems or equipments.
PACKING: 18 kg plastic pail Usually, two layers of application is sufficient but depending on the porosity STORAGE
CONDITIONS/SHELF LIFE: 24 months from date of production if stored properly in unopened and undamaged original sealed containers at temperatures between +5°C to +35°C at dry conditions. Protect from excessive temperature and frost.

Application Photos
ISONEM FLOOR PAINT Application Photos
ISONEM FLOOR PAINT Application Photos
ISONEM FLOOR PAINT Application Photos
ISONEM FLOOR PAINT Application Photos
ISONEM FLOOR PAINT Application Photos
ISONEM FLOOR PAINT Application Photos
Share this product: